Hello Expert
I am doing a VCF 4.5 laboratory which has already been implemented and is working without problems.
If I have had confusion regarding the creation of Edge Cluster to create AVN and install VRLCM. If you can help me check if the configuration that I am doing of the edge Cluster is correct, I would really appreciate it.
They configured me a core which does not support BGP so there is OSPF between the core and the TOR.
They told me that the Tor ASN is 65005 and 65000 with password Lab01##2023, from the Switch downstream
This is where I have the first confusion, because I have the doubt if in Tier0 Routing Type, I select EBGP and if there is, I should put a different ASN to 65000 and 65005, for example 65101 since this ASN does not exist in any configuration.
Then in the TIER-0 Uplink, enter the UPLINK vlan 1647, but in the Tier-0 Uplink Interface IP, I put a segment IP and then in BGP Peer IP (CIDR) I put the GW IP of vlan 1647 with the ASN 65000 and the BGP Peer ASN password.
In the two previous points is where I have the confusion, if what I entered in the Edge Cluster configuration is correct-
Thank you very much in advance, and I attached some screenshots of what was configured.
Regards
Sebastian
I think you have done everything correct 🙂
Thanks fpr your comment.
Hello
Thanks for your comment. I have only one doubt.
In excel declare the range 10.0.244.1 to 10.0.244.8 for Edge Host Overlay but in Edge Cluster it requests Edge TEP 1 CIDR and Edge TEP 2 CIDR and this is my question. I must enter an IP from the range 10.0.244.1 to 10.0.244.8 that I defined in excel or it can be any IP from the range 10.0.244.0/24
Thanks for your comment and help.
Regards
SAN
Edge TEP Network and Host TEP Network needs to be in different VLANs and subnets. Please fill out the Planning and preparation workbook for a better understanding and use that as a reference. Also read the design guides.
Hello
Thank you
I understood, in the NSX-T Host Overlay Network spreadsheet the same vlan as Edge TEP was entered (error)
Edge Overlay TEP is vlan 1644
Host Overlay TEP should be 2500 and not 1644
I will correct the error in excel and make the new VCF deployment
Thanks for your help.
Regards