VMware Networking Community
dima_r
Contributor
Contributor
‎06-09-2022 03:14 AM

Can't configure VXLAN networking in a new cluster

Hello! I am using NSX-V. I have prepared a new host cluster and now I try to set up a VXLAN network on that cluster. But I get the following message: Distributed virtual switch 0 has more than one LAG groups.

What does it mean?

Preview file
49 KB
0 Kudos
2 Replies
Sreec
VMware Employee
VMware Employee
‎06-09-2022 11:02 AM

Have you configured LACP in this setup? I would suggest picking 

  • FAILOVER_ORDER or LOADBALANCE_SRCID  from the list instead of LACP 
Cheers,
Sree | VCIX-5X| VCAP-5X| VExpert 7x|Cisco Certified Specialist
Please KUDO helpful posts and mark the thread as solved if answered
0 Kudos
dima_r
Contributor
Contributor
‎06-10-2022 01:10 AM

Yes, LACP is configured on DVswitch (two LAG). So I can't choose FAILOVER_ORDER or LOADBALANCE_SRCID.

The part of port-groups on DVswitch has a configuration load balancing "Route based on originating port". The other part has a "Route based on IP hash".

0 Kudos